Replacing The Crankshaft Oil Gasket; Replace The Crankshaft Oil Gasket - Nanni T4.155 Workshop Manual

60300140( )
indice A

REPLACING THE CRANKSHAFT OIL GASKET

ADVICE:
There are two methods of replacing the oil gasket (A and B) as described
below

REPLACE THE CRANKSHAFT OIL GASKET

A. When the timing casing cover is separate from the
cylinder block:
a. Use a screw driver and a hammer to drive out the oil gasket.
b. Use special maintenance tool SST and a hammer to fit the new
oil gasket. Enter the gasket until its surface is flush with the
surface of the timing casing cover.
c. Coat the oil gasket lip with grease MP.
B. When the timing case cover is installed on the
cylinder block:
a. Use the special maintenance tool SST to drive out the oil gasket.
b. Coat the lip of the new oil gasket with grease MP.
c. Use special maintenance tool SST and a hammer to fit the new
oil gasket. Enter the gasket until its surface is flush with the
surface of the timing casing cover.
4 CYLINDERS WORKSHOP MANUAL 87/191