Always use the fuels safety regulations before starting the engine. and lubricants recommended by NANNI DIESEL ENGINE EXHAUST WARNING I DANGER Signifies that a very serious danger...
2. Cooling liquid filler hole 2 - GENERAL INFORMATION 3. Block drain plug 4. Fresh water pump Your NANNI DIESEL engine is a product of the 5. Sea water pump research and quality manufacturing of NANNI 6. Alternator INDUSTRIES. It is constructed from the finest materials available, according to finite specifica- 7.
Engine and reversing gear box lubrication 4 - PRE DELIVERY SERVICE Engine Once the engine has been installed on board, - Oil pump driven lubrication system, pressure and before removing the protective covers from regulated by a discharge valve. the various filler holes, clean the external sur- - Disposable cartridge oil filter faces of the engine.
E. Oil pressure switch Coolant fluid Recommendations for the first use E Water temperature switch - Check the tightness of the drain valve located G. Water temperature sender under the turbo, open the air vent valve on the H. Connector top of the turbo volute.
- Allow the engine to idle for several minutes in - The repairs and maintenance must be carried order to stabilise temperatures and turbo speed out by an authorized NANNI DIESEL workshop. - Never increase the engine rev. Before switching off the key! If the engine is used for a number of hours less - Turn the key till the “O”...
Page 8
Periodicity: following maintenance table. For the use of several batteries, install a battery isolator (consult our network). ' (See values on board of technical characteristics) In case of starting the engine with a spare battery Replacement of the seawater pump impeller and jumper cables, proceed in the following man- - Close the seacock valve.
Page 9
Mind the levers position! IMPORTANT: This work must be performed by I DANGER: To avoid bodily injury do not start an authorised NANNI DIESEL engine repair facil- the motor without the air Filter ity. The injectors should be checked every 400...
Page 10
MAINTENANCE Periodical Maintenance Table C/R/A Every Every TYPE OF OPERATION Check Every 200h 400 h Every day Replace 100 h or every or every Adjust year 2 years Cooling liquid level Oil level : gear box Oil level : engine Instrument panel : indications and alarms Belts tension C/A/R...
Oil specification API mini CD - SAE 15 W 40 CAUTION: These specifications are designated for pleasure use only. Recommended cruising speed: 200 rpm below maximum authorised speed. Recommended on-board repair kit for motor type T4.155, 4.380TDI, 4.390TDI DESCRIPTION Quantity V-belt...
Page 13
Nanni Industries S.A.S. 11, Avenue Mariotte - Zone Industrielle BP 107- 33260 La Teste France - Tel : + 33 (0)5 56 22 30 60 - Fax : +33 (0)5 56 22 30 79 E-mail : contact@nannidiesel.com...