Oil Filter Replacement; Reverser Control System; Reverser - Nanni T4.155 Workshop Manual

Oil filter replacement

- The cartridge is of the disposable type.
- Connect a pipe to the sleeve of the filter head bowl and connect to a recipient.
- Unscrew the filter head cartridge.
- Coat the gasket of the cartridge with clean oil.
- Screw the new cartridge onto the filter head, then tighten by hand, ¾ of a turn (do not use tooling).
- Start the engine and check for leaks.
- Stop the engine and top up the oil level if necessary.
WARNING: Hot oil can burn. Avoid any contact with the skin.
Observe environment protection rules.

Reverser

Refer to detailed instructions in the reverser manual attached to the operating manual.

Reverser control system

Check the remote controls on a regular basis. The travel of the cable must be 35 mm either side of the dead point (O
– A = O – B). The lever must be able to travel over its entire course.
Caution: lever positions
DANGER: To avoid any bodily injury, do not start the engine without the air filter.
60300140( )
indice A
4 CYLINDERS WORKSHOP MANUAL 16/191