Setting The Alarm Clock - Roberts Stream 83i User Manual

Setting the alarm clock - cont.
11. If setting the alarm to a radio option, rotate the Tuning/Select control to
highlight the 'Preset:' option then press the control if you wish to change it.
Choose from either the radio station 'Last listened' to, or from the presets 1 -
5. Scroll to the chosen option and press the control to confi rm the selection.
Note that the alarm may only use a preset which has already been stored.
12. Rotate the Tuning/Select control until the 'Volume:' option is highlighted on
the display and press the control if you wish to change it. The sound system
uses the saved volume setting for each alarm when it sounds.
Rotate the control to set the required volume and then press the control to
confi rm the setting.
13. In order to store the alarm settings rotate the Tuning/Select control until
'Save' is highlighted. Press the control to store the alarm settings. Your radio
will show 'Alarm saved' and will then go back to the list of alarms with the new
alarm setting shown in the display.
If you decide not to save the settings, press the Back button. The display will
show 'Save changes' with a 'YES' or 'NO' option. Rotate the Tuning/Select
control to choose 'NO' and then press the control. 'Alarm not saved' will show
on the display.
Active alarms are shown using small alarm indicators at the bottom of the
playing displays and on the clock display when in standby.
Note: If you make a mistake at any point while setting the alarms, use the Back
button to go back to the previous screen.
When the alarm sounds
The buzzer or radio alarm will sound at the selected times for up to 60 minutes
unless cancelled. The volume used for the alarm will be as specifi ed during the
alarm setting procedure. If the radio cannot connect to the specifi ed radio station,
the buzzer alarm will be used instead.
81
11-13