Confi Guration; Plugging In And Language Selection - Roberts Stream 83i User Manual

Confi guration

Plugging in and language selection

1. Place your sound system on a fl at surface and plug the cable from the
mains adaptor into the DC input socket located at the rear of your
sound system (marked 'DC in') ensuring that the plug is pushed fully
into the socket.
2. If you wish to use a wired network connection, plug the Ethernet cable
into the RJ-45 socket at the back of the sound system.
3. Plug the mains adaptor into a wall socket and switch on the socket.
IMPORTANT: The mains adaptor is used as the means of connecting
the radio to the mains supply. The mains socket used for the radio
must remain accessible during normal use. In order to disconnect the
radio from the mains, the mains adaptor should be removed from the
mains socket outlet completely.
4. When you apply power, the display on the radio will light up and say:
'ROBERTS' and 'STARTING' with a progress indicator. The fi rst time
that you use your sound system (or after a Factory Reset) the display
will show 'Setup wizard' and 'YES' will be highlighted on the screen.
5. By default your radio will display all menus and messages in English.
If English is your preferred language then press the Tuning/Select
control to select 'YES' and to begin setting up your sound system.
Then please skip to step 1 on page 10.
6. If your preferred language is not English, then rotate the Tuning/
Select control so that the 'NO' option is highlighted.
Press the Tuning/Select control to enter the selection.
Continue on the next page.
If you need any further advice, please call our Technical Helpline on 020 8758 0338 (Mon-Fri)
Confi guration
5,6
8