Setting The Alarm Clock - Roberts Stream 83i User Manual

Setting the alarm clock

Your sound system has two separate alarms which can be set to wake you
to either the radio or a buzzer alarm. In the event of a power interruption your
sound system has built in memory that will retain your alarm settings.
Ensure that the time is set correctly before setting the alarms.
Alarms may be set while the radio is in standby mode or switched on.
1. To change the states of the alarms while the sound system is in standby
press the Preset 3 button. The display will cycle through No Alarm,
Alarm 1 enabled, Alarm 2 enabled or Alarms 1 and 2 enabled.
2. To change the alarm settings while the sound system is in standby,
press and hold the Preset 3 button. This will cause the Alarms menu
to be displayed. Then skip to step 5 below.
3. To change the alarm settings while the sound system is switched
on, press the Menu button to access the menu for the current mode.
Rotate the Tuning/Select control until 'Main menu' is highlighted on
the display. Press the control to enter the Main menu.
4. Rotate the Tuning/Select control until 'Alarms' is highlighted on the
display. Press the control to see the current alarm settings. If no change
is required, press the Menu or Back buttons to exit.
5. Rotate the Tuning/Select control until the desired alarm (1 or 2) is
highlighted on the display. Press the control to enter alarm setup.
6. Rotate the Tuning/Select control until 'Time' is highlighted on the
display. Press the control to adjust the alarm time.
7. Rotate the Tuning/Select control to choose the alarm hour. Press the
control to confi rm the setting.
79
1,2
3
3-7