Aeros Discus 12 Owner's Manual page 14

11. At the wingtips, lay the sail at the tip out flat, and fold the wingtip forward over onto the bottom surface of the sail (
).
26
Working from the trailing edge, roll the sail tightly to the leading edge (
Note: If you're breaking down in a dirty, rocky and/or abrasive area, you can combine this step with step 7 above, by
pivoting the wing inwards enough to allow you to flip the sail at the tip over the top of the leading edge, fold forward
and roll up the wing tip and put it in the tip cover bag.
12. Finish rolling the sail in the area of the sprogs. Secure the sail with the velcro sail ties. The first velcro tie is installed by
passing it over the top of the keel tube just near the Crossbar-LE tube junctions, and then installing it around the glider
leading edges ( ).
Photo 28
13. Install the sail velcro around the sail forward of the control bar
apex, and stow the nosecone between the leading edges (
).
30
Photo 26
Photo 27
Photo 28
,
Photo 29
13
), and install the tip cover bag.
Photo
Photo 27
Photo 29
3
Photo 0