Pride Libre SCOOTER SERIES Owner's Manual page 32

V I I . B A S I C T R O U B L E S H O O T I N G
BEEP CODE POSSIBLE CONDITIONS
3,3 1. Low battery voltage.
2. KSI and throttle turned on at same
3,4 1. Electromagnetic brake driver open.
2. Electromagnetic brake coil shorted.
3,5 1. Improper sequence of throttle and
2. Misadjusted throttle pot.
4,1 1. Short in motor or in motor wiring.
2. Controller failure.
4,2 1. Motor voltage does not correspond
2. Short in motor or in motor wiring.
3. Controller failure.
4,3 1. EEPROM failure or fault.
4,4 1. EEPROM failure or fault.
2. Short in motor or in motor wiring.
What if the motor runs, but my Travel Scooter does not move?
Your Travel Scooter was probably left in freewheel mode.
When the manual freewheel lever is pushed forward, the brakes are disengaged and all power to the motor/
transaxle is cut.
Pull the manual freewheel lever rearward to restore normal operation to your Travel Scooter.
What if the main circuit breaker trips repeatedly?
Charge the Travel Scooter's batteries more frequently. See IV. "Batteries and Charging."
See IV. "Batteries and Charging" or "Appendix I - Specifications" for information about your Travel Scooter's
battery type.
If the main circuit breaker trips repeatedly, contact your authorised Pride Dealer for service.
What if the battery condition meter dips way down and the motor surges or hesitates when I press the
throttle control lever?
Fully charge your Travel Scooter's batteries. See IV. "Batteries and Charging."
Have your authorised Pride Dealer load test each battery.
32
time.
KSI, or throttle and inhibit inputs.
to failsafe throttle request.
www.pridemobility.com
SOLUTION
Charge batteries.
Restart the Travel Scooter without
touching the throttle control lever.
Contact your authorised Pride Dealer.
Turn key to the off position, then back to the on
position.
Contact your authorised Pride Dealer.
Contact your authorised Pride Dealer.
Contact your authorised Pride Dealer.
Contact your authorised Pride Dealer.
Pride Scooter Series