Software Installation - Martin Professional MAC TW1 User Manual

To replace fuses:
1. Disconnect the fixture from power and the external dimmer system, if used, and allow to cool for 45
minutes.
2. Take precautions to avoid damage by static discharge.
3. See Figure 13. Remove the four screws (arrowed) from the outer edges of the connections panel cover
and pull the cover away from the fixture base for access to the PCBs.
Figure 13: Fuse replacement
4. See Figure 13. Fuses marked A and B protect the main power circuit. Fuses C and D protect the
external dimmer lamp power circuit.
5. Replace defective fuses with ones of the same type and rating only. Fuses are available from Martin,
P/N 05020051.
6. Replace and secure the connections panel cover before reapplying power or reconnecting an external
dimmer system.

Software installation

Software updates are available from the Martin web site and can be installed via the data link with a Martin
upload device.
The following are required in order to install software.
• The MAC TW1 update file, available for download from the User Support Area of the Martin web site at
http://www.martin.com/service
• The Martin Software Uploader program, version 5.0 or later, available for download from the User Support
Area of the Martin web site.
• A Martin MP-2 Uploader connected to a Windows 95/98/ME/2000/XP PC, or one of the PC controller
DMX interfaces supported by the Martin Software Uploader software.
T o in st al l so ftw ar e, n or mal meth od
Please refer to the MP-2 user manual and the Martin Software Uploader online help file.
T o in st al l so ftw ar e if all el se fails (boo t sector update)
Note: Use this procedure only if the firmware is totally corrupted, which is evident if the control panel does
not respond when power is applied, or if the software update notes call for a boot sector update. In the event
of a check sum error, repeat the normal upload procedure.
1. Disconnect the fixture from power.
2. Remove the side cover from the side of the base that has the control panel to expose the main PCB.
3. Locate the "BOOT" jumper on the main PCB (see page 36) and move the jumper cap to the "INIT"
position.
4. Perform a boot mode upload as described in the uploader documentation.
5. When the upload is complete, disconnect the fixture from power and move the jumper back to the
"DISABLE" position.
6. Reassemble the base.
Service and maintenance
A
B
C
D
27