Display Messages - Martin Professional MAC TW1 User Manual

Display messages

Message

(Reset)

(Serial reset)
 
or

(Memory error)

(Feedback error pan)

(Feedback error tilt)

(Feedback error pan/tilt)

(Pan time-out)

(Tilt time-out)

(Zoom time-out)

(Cyan time-out)

(Magenta time-out))

(Yellow time-out)

(Head temperature cutout)










34
Appears when...
... the fixture is indexing effects at startup.
... the fixture has received a reset command
via DMX.
...there is no communication between the
control panel and motherboard (this display
appears briefly when powering the fixture on).
...the EEPROM memory cannot be read.
...the pan and/or tilt correction systems cannot
correct a loss of step (or there is a malfunction
in the pan/tilt monitoring circuit such as a
defective sensor). After a time-out, the head
stops in a random position.
...there is a malfunction in the position
indexing circuit for pan, tilt or zoom. The
fixture will, after the time-out, establish a
mechanical stop, and continue to work
although calibration will be imprecise.
...there is a malfunction in the electric indexing
circuit for one of the CMY filters.
...the head temperature is above maximum.
...one or more motor drivers fail.
... the real time clock is not running correctly.
...there is an onboard programming error.
...there is a display programming error.
...there is an internal dimmer error.
...there is a problem updating the internal
dimmer firmware.
...the fixture has entered lamp explosion mode
because it has detected a lamp failure. Pan
and tilt are locked and DMX control is
disabled.
...there is a base fan error.
...there is a lamp fan error.
...there is a head fan error.
Table 6: Display messages
MAC TW1 user manual
What to do
Wait for reset to complete.
Wait for reset to complete. Note that
→
 
you can set
to prevent accidental DMX reset
commands.
Check fuses.
Check cable and connectors between
control panel and motherboard.
Reinstall fixture software.
Contact Martin service if the above do
not solve the problem.
Contact Martin service personnel for
assistance.
Reset fixture.
Contact Martin service personnel if
problem continues.
Reset fixture.
Contact Martin service personnel if
problem continues.
Reset fixture.
Contact Martin service personnel if
problem continues.
Ensure free airflow around air vents.
Clean fixture as described in manual.
Check that ambient temperature does
not exceed max. permitted level.
Contact Martin service personnel for
assistance.
Contact Martin service personnel for
assistance.
Contact Martin service personnel for
assistance.
Contact Martin service personnel for
assistance.
Contact Martin service personnel for
assistance.
Contact Martin service personnel for
assistance.
Contact Martin service personnel for
assistance.
Check lamp. Pan and tilt are released
and DMX control is re-enabled when
power is reapplied.
Contact Martin service personnel for
assistance.
Contact Martin service personnel for
assistance.
Contact Martin service personnel for
assistance.

to