Hardware Identification Chart - Stamina 1333 Precision Power Owner's Manual

HARDWARE IDENTIFICATION CHART

This chart is provided to help identify the hardware used in the assembly process. Place the washers or
the ends of the bolts or screws on the circles to check for the correct diameter. Use the small scale to
check the length of the bolts and screws.
3/16" 1/4"
0 1/2 1
0 10 20
6
NOTICE: The length of all bolts and screws, except those with flat
heads, is measured from below the head to the end of the bolt
or screw. Flat head bolts and screws are measured from the
top of the head to the end of the bolt or screw.
After unpacking the unit, open the hardware bag and make sure that you have all the following items.
Some hardware may be already attached to the part.
5/16" 3/8"
1/2 2 1/2
30 40 50 60
8 10
Part Number and Description
31
33
35
36
39
40
41
42
43
44
46
47
1/2"
3 1/2 4
70 80 90 100 110 120 130 140 150
MILLIMETERS
12
Lock Washer (M8)
Washer (ø8 x ø23 x 2mm thick)
Nut (M8 x 1.25)
Nylock Nut (M8 x 1.25)
Screw, Round Head (M5 x 15mm)
Bolt, Round Head (M6 x 1 x 25mm)
Bolt, Button Head (M8 x 1.25 x 15mm)
Bolt, Button Head (M8 x 1.25 x 25mm)
Bolt, Button Head (M8 x 1.25 x 35mm)
Bolt, Button Head (M8 x 1.25 x 40mm)
Carriage Bolt (M8 x 1.25 x 90mm)
Bolt, Hex Head (M8 x 1.25 x 120mm)
6
INCHES
1/2 5 1/2
length
length
6
in.
mm.
Qty
6
4
2
6
2
2
2
6
4
2
2
2