Operational Instructions; Storage; Maintenance - Stamina 1333 Precision Power Owner's Manual

OPERATIONAL INSTRUCTIONS

LOAD ADJUSTMENT
The resistance of the shocks can be adjusted by twisting the adjustment
knob at the top of the shocks. There are settings from 1 to 12. Setting
#1 will provide the lowest resistance. Setting #12 will provide the highest
resistance.
CAUTION: The shocks get HOT after a few minutes of use. Allow to cool
before moving.

STORAGE

1. To store the 1333 Precision Rower, simply keep it in a clean dry place.
2. To avoid damage to the electronics meter, remove the batteries before storing the 1333 Precision
Rower for one year or more.
3. Move the ATS Air Rower 1402 with the moving wheels on the Front Stabilizer on the MAIN
FRAME(1). Grasp and lift the REAR STABILIZER(8) to move the 1333 Precision Rower. Do not
use the SEAT(28) to move the 1333 Precision Rower. The SEAT(28) will move and the SEAT
CARRIAGE(24) may pinch your hand or fingers.

MAINTENANCE

The safety and integrity designed into the 1333 Precision Rower can only be maintained when the 1333
Precision Rower is regularly examined for damage and wear. Special attention should be given to the
following:
1. Pull on the HANDLEBARS(16, 17) and verify that the SHOCKS(11) provides resistance.
2. Clean the roller tracks on the CENTER BEAM(18) with an absorbent cloth.
3. Verify that all nuts and bolts are present and properly tightened. Replace missing nuts and bolts.
Tighten loose nuts and bolts.
4. Verify that the CAUTION LABEL(48) is in place and easy to read. Call Stamina Products immediately
at 1-800-375-7520 for a replacement CAUTION LABEL(48) if it is missing or damaged.
5. It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
6. Worn or damaged components shall be replaced immediately or the 1333 Precision Rower removed
from service until repair is made.
7. Only Stamina Products supplied components should be used to maintain/repair the 1333 Precision
Rower.
8. Keep your 1333 Precision Rower clean by wiping it off with an absorbent cloth after use.
12
Adjustment
Knob
Mark