None Key - Aastra 9480i User Manual

Line Keys and Softkeys
Using the Paging Key
The following procedure describes the use of the Paging key on the IP Phone. The procedure assumes you have already
configured the Paging key using the Aastra Web UI.
IP Phone UI
Notes:
1. Recipient of a Paging call can set a global "Do Not Disturb" (DND) to ignore any incoming pages.
2. For incoming Paging, the phone uses the Intercom configuration settings. The incoming Page is dependant on the
"Allow Barge-In" parameter setting and the "Idling/On Call" state.
1.
On the IP Phone, press the softkey or programmable key you configured for
Paging (labelled as "Group 1" in the following illustration).
The phone opens a multicast RTP session and an outgoing OR incoming phone screen displays as follows.
2. Press the Drop key to end the multicast RTP session and return to the idle screen.
Note:
If you enable global DND on the phone, the incoming multicast RTP session is dropped.

None Key

You can set a key to force a blank entry on the IP phone display for a specific key. You do this by setting the key to "none".
The keys are added in order (from key 1 to key 20) after any hard-coded keys have been added. If a particular key is not
defined, it is ignored. For more information about key behavior, see
90
L1 John Smith
01/01/14 11:00am
Group 1
LAB
ACD
L1 John Smith
Paging
00:01
Drop
"Key Display Behavior" on page 47.
41-001382-05 REV03 – 07.2014