Subaru 2003 LEGACY Service Manual page 16

GLASS/WINDOWS/MIRRORS
6) Adjust so that upper and lower ends of center pil-
lar are the same size.
(1) Glass tilts too far rearward
(2) Narrow
(3) Wide
(4) Lower B channel
(5) Glass tilts too far forward
(6) Raise B channel
7) For glass stroke adjustment, close door, raise
glass until positional relationship between glass
and weatherstrip becomes as shown. And secure
the glass so that upper stopper lightly touches the
glass holder.
A
A
(1) 2.5±0.5 mm (0.098±0.020 in)
(2) 6 mm (0.24 in)
FRONT DOOR GLASS
( 2 )
( 1 )
( 3 )
( 4 )
( 3 )
( 5 )
( 2 )
( 6 )
GW-00093
( 1 )
6
(0.24)
GW-00146
A-A
8) After stabilizer adjustment, carry out glass crimp
adjustment. First, visually ensure positional rela-
tionship between retainer & molding and glass of
the roof side, and then begin with rear sash adjust-
ment. Adjust two adjusting bolts alternately step by
step to obtain dimensions shown below (cross-sec-
tion A).
NOTE:
If two nuts are loosened at the same time, sash
moves back and forth. Therefore, when one nut is
adjusted, secure the other.
9) Make the same adjustment of two adjusting bolts
of rear sash.
(1) 2.5±0.5 mm (0.098±0.020 in)
(2) 6 mm (0.24 in)
NOTE:
Do not tilt sash bracket to inner panel during adjust-
ment. Otherwise smooth regulator operation can-
not be achieved.
( 1 )
( 2 )
(1) Sash bracket
(2) Rear sash
(3) Adjust a line parallel
(4) Sash
(5) Inner panel
GW-14
( 1 )
A
A
6
(0.24)
GW-00146
A-A
( 3 )
( 4 )
( 5 )
GW-00096