Subaru 2003 LEGACY Service Manual page 27

B: INSTALLATION
1) Cut off nozzle tip as shown in the figure.
15 (0.59)
12 – 15
(0.47 – 0.59)
(1) Dam rubber
(2) Locating pin
(3) Adhesive
(4) Molding
(5) Unit: mm (in)
2) Install glass in the same procedure as for wind-
shield glass. <Ref. to GW-18, INSTALLATION,
Rear Regulator and Motor Assembly.>
3) After completion of all work, allow vehicle to
stand for about 24 hours.
NOTE:
For minimum drying time and time the vehicle must
be left standing before driving after bonding, follow
instructions or instruction manual from the adhe-
sive manufacturer.
4) After curing of adhesive, pour water on external
surface of vehicle to check that there are no water
leaks.
NOTE:
When a vehicle is returned to the user, tell him or
her that the vehicle should not be subjected to
heavy impact for at least three days.
REAR QUARTER GLASS
( 1 )
( 2 )
( 3 )
( 4 )
GW-00119
GW-25
GLASS/WINDOWS/MIRRORS