Subaru 2003 LEGACY Service Manual page 22

GLASS/WINDOWS/MIRRORS
B: INSTALLATION
1) Clean external circumference of windshield
glass with alcohol or white gasoline.
2) Remove adhesive layer on the body using cutter
knife to obtain smooth face 2 mm (0.08 in) thick.
2 mm
(0.08 in)
(1) Adhesive
(2) Dam rubber
(3) Glass
3) Clean body with alcohol or white gasoline to re-
move thoroughly chips, dusts, and dirts from body
face.
4) Place glass on body.
5) Adjust glass position to make uniform clearance
between body and glass in four corners.
6) Place locating pins (A) and body on glass.
7) Remove glass from body.
WINDSHIELD GLASS
( 1 )
( 2 )
( 3 )
GW-00111
( A )
GW-00112
8) Fit molding mark (B) to notch (A) of ceramic
print.
9) Apply primer to adhesive layer (A) of glass (B)
using sponge.
10) Apply primer to adhesive layer (A) of body (C).
NOTE:
• Primer once attached to the painted surface of
the body and internal trim is hard to wipe off. Mask
the circumference of such areas.
• Let primer dry for about ten minutes before in-
stalling the glass.
( B )
GW-20
( A )
( B )
GW-00113
( A )
( C )
GW-00114