Yamaha TF5 User Manual page 16

4
Meter display
Display the post-fader channel level.
Two meters are displayed for AUX 9/10–19/20, STEREO, and MONITOR channels.
Meters are not displayed for DCA channels.
5
CUE button
Turns the channel's cue on and off. This button lights up when the cue is turned on.
The CUE button is not displayed for the MONITOR channel.
CH Name area
Allows you to adjust the channel's pan/balance, and displays the channel's number, name, icon, and color.
1
Pan/balance slider
Drag left and right to adjust the pan or balance of the channel.
The control stops at the center position; you can then continue to drag it left or right as desired.
When the pan or balance is set to the center position, a round icon is displayed. You can also double-tap this area to set the
pan or balance to the center position.
You can adjust pan/balance for multiple channels at the same time.
2
Channel display
Displays the channel number, name, icon, and color.
Overview strip area
The STEREO channel strip is normally displayed in the overview strip area. When using SENDS ON FADER mode, the destination
AUX channel or SUB channel strip is displayed here.
You can switch to SENDS ON FADER mode by tapping a channel number displayed on the left side of the strip. The selected
channel will be highlighted in the channel's color. Tap off near the bottom of the strip to exit SENDS ON FADER mode.
If you enter SENDS ON FADER mode while an FX channel is selected, nothing is displayed here.
- 16 -
Screen areas
TF StageMix
User's Guide