To Fix The Runners - Belling BI 60 LPG Service Manual

installation instructions - 70cm
Method 2: Housing unit with
internal height less than 710mm.
Note: You will not need the 2 side trims
(687mm long) or the appliance runners
for this installation. You will need the 2
runners to fix to the adjacent cabinets.
Before you start;
Before removing the bottom shelf or
modifying the housing unit, make sure
that it will remain structurally sound, eg;
by fixing to adjacent cabinets, floor or
worktop.
You may have to cut into or remove any
rear cross members to obtain the 550mm
minimum depth.
To obtain the required 710mm height,
you may have to lower or remove the
bottom shelf - remove any cross rails and
reposition brackets.
to fix the runners (if required)
1. Take the side trims, hold it against
the side of the base unit, and use it to
mark off the 687mm from the top
edge of the side unit, to the top edge
for the runner.
Note: This ensures a 5 - 8mm
clearance from the underside of the
worktop to the top of the appliance.
2. Measure 50mm from the front edges
of the base units, to mark the front
edge for the runners.
3. Take 6 of the No 8 x 12mm (Black)
chipboard screws and screw the
runners into position the right way up
as shown.
4. If necessary, adjust the height of the
plinth to just below the bottom edge of
the runners.
If you require a replacement fixing kit
please call the customer care helpline and
order part number 01 28287 00.