Cleaning; Painted And Plastic Parts; Stainless Steel And Aluminium Surfaces; Enamel Surfaces And Parts - Belling BI 60 LPG Service Manual

geneRal
• It is important to clean the product
regularly as a build up of fat can affect
its performance or damage it and may
invalidate your guarantee.
• Always switch off your appliance and
allow it to cool down before you clean any
part of it.
• Do not use undiluted bleaches,
products containing chlorides, wire wool
or abrasive cleaners on aluminium,
stainless steel, or plastic / painted parts
as they can damage the appliance. Nylon
pads can also be unsuitable.
• Take extra care when cleaning over
symbols on fascia panels. Excessive
cleaning can lead to the symbols fading.
Painted & Plastic parts
• Only use a clean cloth wrung out in
hot soapy water.
• Do not use abrasive cleaners, such
as "Cif", wire or nylon cleaning pads on
these parts.
Stainless steel & aluminium surfaces
• Only use a clean cloth wrung out in
hot soapy water, and dry with a soft cloth.
• Stubborn marks can be removed using
a stainless steel cleaner. Supplies can
be purchased from the Customer Care
Centre.
• Sharp objects can mark the surface
of stainless steel, but will become less
noticeable with time.
• Wipe any spillage immediately, taking
care to avoid burning your hands.
• Some foods are corrosive eg; vinegar,
fruit juices and especially salt - they can
mark or damage the metal if they are left
on the surface.

cleaning

• Baby oil can be used to restore
stainless steel finishes - but only use a
few drops. Don't use cooking oils as they
can contain salts, which will damage the
metal.
• Do not use steam cleaners.
enamel surfaces & parts
• Clean with warm, soapy water and a
clean cloth.
• If larger splashes of fat do not readily
disappear, you can use a mild cream
cleaner to remove them. More stubborn
marks can be removed using a soap filled
pad.
• Rinse well and dry with a soft clean
towel or cloth.
• Do not use steam cleaners.
glass parts
• Only use a clean cloth wrung out
in hot soapy water, or a specialist glass
cleaner.
• Rinse away any excess cleaner and dry
with a soft cloth.
• Do not use abrasives or polishes as
they will scratch and damage the glass.
chrome plated parts
• Use a moist soap filled pad, or place
in a dishwasher.
ReMOVing OVen PaRTS FOR cleaning
inner Door glass
• The inner door glass panel can be
removed for cleaning but it must be
replaced the right way up. If there is any
writing on the glass, you must be able to
read it clearly when the cavity doors are
open.
• Always make sure that the glass is
pushed fully into the Stop position.