Table of Contents
Advertisement
ACCESSORIES
INDIVIDUAL HEADREST (L55)
The standard backrest can be enhanced by an individually adjustable head support supplied by us.
This comprises a cushioned headrest which can be set in various positions by means of a gearwheel
(see diagram).
The receptacle screwed in the upper third of the back, can be fixed to the centre of the back for
inserting the headrest. The height of the headrest can be adjusted and then tightened at the desired
height. The holes required for fixing the headrest have already been drilled in the back unit.
L
Make sure that the headrest is inserted at least to the marked position to be fixed securely and
reliably.
The depth of the headrest can be adjusted by slightly loosening the adjusting screws to allow
movement of the sprocket gears. Then you can adjust the headrest to your needs and secure it by
retightening the adjusting screws. If the adjusted position is not satisfactory, you can repeat this
process.
L
Ensure that the back of your head is supported when relaxed in an upright sitting position.
L
Before using the headrest all fixing screws must be tightened properly, since injuries might
result when it slips downwards unintentionally.
You can secure your head against tipping sideways by lightly pressing the side panels of the headrest
inwards and to the front.
L
Do not exert too much pressure on the side panels otherwise bruising may result.
L
Do not clap the side panels together violently, otherwise they might break off, causing possible
injury as well as loss of function.
Structural alterations of the headrest would void any warranty.
LEG SUPPORTS
If the leg supports supplied with the wheelchair do not meet your requirements, you could consider leg
supports with adjustable height. Because the footrest attachment is standardised, it can be assembled
in the same way as described in the section on foot supports.
Kindly consult your specialist dealer if you have questions about other footrest systems; he shall gladly
advise you about the indication and function of our available foot supports.
PERSONAL SAFETY SYSTEM (B58)
For your safety we offer you a standardised safety belt which is equipped with a snap-on fastener, like
those mounted in cars and vans. This can be fixed by means of bolts inserted in the bolt holes on both
sides of the seat frame next to the backframe attachments. To ensure proper fixing, self-locking
("nylock") nuts should be used.
If the belt has been dismantled, only new genuine nuts provided by the manufacturer should be used
for re-attachment.
L
To ensure the validity of the warranty, entrust this work to your specialist dealer.
L
Before using the seatbelt, make sure that all screws are properly tightened.
SQUOD Instruction Manual
Last updated: Jul. 2005
17
Advertisement
Table of Contents
