Armrests; Batteries - Vermeiren Squod Instruction Manual

L
Never grasp the wheelchair by the leg supports when picking it up for transportation, but only
by solid frame parts (see also the chapter "For your safety".)
L
Make sure that the footplates are at least 6 cm above the ground to avoid contact with the
ground when driving; such contacts may cause damage and endanger the operational security
of the wheelchair. In addition, the user could also be injured.

ARMRESTS

2
1
L
Never pick the wheelchair up for transportation by the armrests, but take hold of solid frame
parts only.
The armrest containing the steering electronics can only be detached if the cable connected to the
steering electronics has been removed previously.
L
The armrests may only be turned down or removed when the user of the wheelchair is
safeguarded against tipping out sideways.
If changes, damage, or wear of the suspension are noticeable, kindly consult your specialist dealer
who can remedy these defects.
L
To avoid endangering your safety, do not use the wheelchair when changes, damage, or wear
of the suspensions are noticeable.
L
If you contemplate changing the armrests and/or the armrest supports, that would be entirely
your own responsibility. Your guarantee will be voided.

BATTERIES

The standard for your electric wheelchair is two closed 12 Volt gel batteries each with a capacity of 73
Ah. These batteries are suitable for driving your electric wheelchair.
If the batteries lose their power after long usage, or if they are damaged, let both be replaced by a
specialist dealer only.
L
We shall decline all liability for damage caused by the use of improper batteries.
L
Do not expose the batteries to temperatures below 5° Celsius or above 50° Celsius.
L
If the batteries are opened, every liability of the manufacturer shall be voided as well as any
claim.
The armrests can be adjusted upwards and taken out by
loosening the screw (1) and pulling the armrest upwards.
To adjust the width between the armrests, you only have to
loosen screw (2) and place the armrest in the desired position.
The screw must be tightened properly afterwards.
L
Make sure that all fixing screws are properly tightened
before using the wheelchair, otherwise injury and/or
damage can be caused.
L
When carrying out adjustments, make sure that
everything is securely tightened again afterwards.
SQUOD Instruction Manual
Last updated: Jul. 2005
10