Trouble Shooting - Pace Technologies MEGA-T300 Instruction Manual

- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - ▲
3601 E. 34th St. Tucson, AZ 85713 USA Tel. +1 520-882-6598 Fax +1 520-882-6599 email: pace@metallographic.com

6.0 Trouble Shooting

More extensive trouble shooting, repair guides, video's, parts list are provided
online at www.metallographic.com or
http://www.metallographic.com/PACE-service/MEGA-T300-service.html
Problem
No power or function
Main motor does not
operate
Pump motor does not
operate
Excessive vibration
during cutting
Shipped in the
Unlock position
Please read this instruction manual carefully and follow all installation, operating and safety guidelines.
MEGA-T300 Abrasive Cutter
Cause
a. Unit is disconnected from
main electrical power supply.
b. Main power switch is off.
c. Emergency stop button
engaged.
a. Interlocking safety switch is
in Unlock position (for
shipping)
b. Hood not closed.
c. Overload relays activated
a. Plug is disconnected
b. Overload relay activated
a. Not cutting with enough force
b. Specimen locked too far back
on cutting table
c. Incorrect blade selection
Turn to Lock position
to operate saw
I
NSTRUCTION
Web: http://www.metallographic.com
Solution
a. Verify electrical source and
connection.
b. Turn on main power switch.
c. Release by turning clockwise.
a. Turn safety switch to Lock
position to operate cutter.
b. Close hood
c. Restart after resetting Q1 relay.
a. Check plug.
b. Restart after resetting Q2 relay.
a. Increase cutting force.
b. Move specimen forward.
c. Use correct blade.
If motor or pump
does not turn on
check Q1 - motor
and Q2– pump
relays
M
ANUAL
18