Pace Technologies MEGA-T300 Instruction Manual page 15

- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - ▲
3601 E. 34th St. Tucson, AZ 85713 USA Tel. +1 520-882-6598 Fax +1 520-882-6599 email: pace@metallographic.com
3.4 Safety Tests
Emergency stop switch
Magnetic Safety switch
Please read this instruction manual carefully and follow all installation, operating and safety guidelines.
MEGA-T300 Abrasive Cutter
Examine and verify that the MEGA-T300 safety devices
!
and operating performance are in good working
condition prior to use. The following safety checks are
considered important:
Emergency stop switch
Test:
Proper
Response:
Malfunction:
Corrective
measure:
Magnetic safety lock out switch
Test:
Proper
Response:
Malfunction:
Corrective
measure:
I
NSTRUCTION
Web: http://www.metallographic.com
Activate main switch and close hood;
depress emergency stop switch.
Machine powers down.
Machine does not lose power.
If system does not power down,
disconnect power supply cord and call
service technician.
Activate main switch and close hood;
turn cut-off wheel ON then OFF;
Try to open the hood.
Hood does not open for approximately 5
seconds.
Hood opens immediately.
If cut-off wheel does not power down,
disconnect power supply cord and call
service technician.
M
ANUAL
11