Pace Technologies MEGA-T300 Instruction Manual page 11

- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - ▲
3601 E. 34th St. Tucson, AZ 85713 USA Tel. +1 520-882-6598 Fax +1 520-882-6599 email: pace@metallographic.com
2.3 Installation
!
Install unit carefully! Improper installation voids warranty.
The MEGA-T300 should be placed on a flat
stable surface.
!
TO OPEN HOOD, CUTTER IS SHIPPED WITH THE
LOCKOUT SWITCH TURNED TO UNLOCK. AFTER
CONNECTING POWER, TURN SWITCH TO
LOCK TO OPEN HOOD AND TO USE CUTTER
Connect coolant tank
supply, drain and
electrical connections.
Electrical connections—The standard saw is designed to operate at 208-220V 3-phase
!
(120V-120V-120V-ground) (optional 380/400/480V)
Verify voltage on nameplate
Verify the direction of rotation of the cut-off wheel. The wheel should turn from top to bottom
!
as viewed from the front of the machine.
Please read this instruction manual carefully and follow all installation, operating and safety guidelines.
MEGA-T300 Abrasive Cutter
(Installation continued on next page)
I
NSTRUCTION
Web: http://www.metallographic.com
Before installation or when there
is no power to the machine, the
hood cannot be opened with the
interlocking safety device in the
LOCK position. To open the
hood without power hook-up,
turn the interlocking device with
key to the UNLOCK position
(used for service and shipping).
Turn to Lock
Shipped in the
position to operate
Unlock
Main Power switch
M
ANUAL
CAUTION
7