Maintenance - Pace Technologies MEGA-T300 Instruction Manual

- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - ▲
3601 E. 34th St. Tucson, AZ 85713 USA Tel. +1 520-882-6598 Fax +1 520-882-6599 email: pace@metallographic.com

5.0 Maintenance

5.1 Introduction
The MEGA-T300 requires very minimal maintenance. However, to increase the life of the
saw, it is suggested that the cutting chamber be rinsed after cutting.
It is also recommended that the hood be left open in order to minimize corrosion inside of the
chamber due to high humidity from the cutting operation and cutting fluid.
5.2 Cleaning outside cabinet
The cabinet and front shield should be cleaned occasionally with a moistened cloth. Do not
use any chemicals or cleaning abrasives. We recommend an anti-condensation gel be used
on the front panel.
Please read this instruction manual carefully and follow all installation, operating and safety guidelines.
MEGA-T300 Abrasive Cutter
I M
NSTRUCTION ANUAL
Web: http://www.metallographic.com
17