Start-Up And Operation - Pace Technologies MEGA-T300 Instruction Manual

- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - ▲
3601 E. 34th St. Tucson, AZ 85713 USA Tel. +1 520-882-6598 Fax +1 520-882-6599 email: pace@metallographic.com

4.0 Start-up and Operation

4.1 General
The MEGA-T300 is a manual wheel and manual table feed cutter.
4.2 Control Panel
Cutting wheel ON/:
Cutting wheel OFF/:
Coolant ON/OFF:
Light ON/OFF:
Please read this instruction manual carefully and follow all installation, operating and safety guidelines.
MEGA-T300 Abrasive Cutter
Light
ON/OFF
Coolant
ON/OFF
Starts the cutting wheel.
Stops the cutting wheel (inductive brake engages to slow
wheel). Hood cannot be opened until safety lock releases in
approximately 5 seconds after pressing the stop button.
Operates the coolant pump in Auto or Manual mode.
Turns inside chamber light On or Off.
I M
NSTRUCTION ANUAL
Web: http://www.metallographic.com
Power
Light
Cutting
wheel (ON)
Cutting
wheel (OFF)
12