Advanced Settings For Dsc/Wkr - JRC JSS-2150 Instruction Manual

Settings & Registrations

5.5 Advanced settings for DSC/WKR

The following describes the procedure for the advanced DSC settings such as automatic
acknowledgement, as well as setting the watch frequency of the watch keeping receiver.
■
Menu screen
Press the
MENU
hierarchical menus, select 7.5 DSC/WKR
condition.
The following describes the procedures from
this screen. Note that the screen at right
shows factory default settings.
5.5.1 Automatic acknowledgment
If any one of the individual calls below is received when the automatic acknowledgement is set to
ON and no menu is displayed, the acknowledgement is sent automatically without notice.
Safety - a test call
Safety - a position request call
Routine - a polling call
■ ■
Procedure
1 .
1 .
1 .
Move the cursor to 1. Automatic ACK,
and press ENT.
The screen as shown at right is displayed.
2 .
2 .
2 .
Set the call setting targeted for
automatic acknowledgement to ON.
5-10
■
key, and through
7.5)DSC/WKR condition
1.Automatic ACK
2.WKR scanning FRQ
3.Safety/Routine alarm :ON
4.Medical/Neutral use
5.Group ID : [0
0.Back
7.5.1)Automatic ACK
1.Test call :ON
2.Position RQ call :ON
3.Polling call :ON
0.Back
:OFF
]