JRC JSS-2150 Instruction Manual page 78

Operation
6 .
6 .
6 .
Select Call and press ENT to start the
procedure for making a test call.
The sending procedure screen as shown at
right is displayed.
After that, the status is shown at Stage. Here
it is checking if the channel is free.
7 .
7 .
7 .
When a free channel is confirmed, the
antennas are tuned, and a DSC message
is sent.
8 .
8 .
8 .
After the DSC message is sent, wait for
acknowledgement.
9 .
9 .
9 .
When a reply is received, the reply
message is displayed as shown at the
right.
The ALM lamp starts blinking, and the call
alarm gradually grows louder.
Press either the
silence the alarm and display Close. Press
ENT to display the status display.
The test call process is now complete
because there is no communication using the
radiotelephone.
- Press the
Note
- According to the condition of the station and the radio wave propagation
conditions, the acknowledgement may not be received even if the equipment
works normally.
4-36
CANCEL key or ENT to
T E S T
O key while holding the
C A L L
I D 4 3 1 0 0 1 2 3 4 T I M E 2 3 : 5 9 ( U T C )
P o s 8 9 ﾟ 5 9 . 0 1 2 3 ' N
1 7 9 ﾟ 5 9 . 6 7 8 9 ' E @ 2 3 : 5 9
D S C R x : 4 2 0 7 . 5 / T x : 4 2 0 7 . 5 k H z
S a f e t y t e s t c a l l
S t a g e : W a i t i n g f o r C H f r e e
T i m e : 0 . 1 m i n a f t e r c a l l i n g
C a l l - F : 4 2 0 7 . 5 / 4 2 0 7 . 5 k H z
[ C a n c e l ] [ C a n c e l ]
W K R s c a n b a n d s :
2 4 6 8 1 2 1 6 ( M H z )
I D 4 3 1 0 0 1 2 3 4 T I M E 2 3 : 5 9 ( U T C )
P o s 8 9 ﾟ 5 9 . 0 1 2 3 ' N
1 7 9 ﾟ 5 9 . 6 7 8 9 ' E @ 2 3 : 5 9
D S C R x : 4 2 0 7 . 5 / T x : 4 2 0 7 . 5 k H z
S a f e t y t e s t c a l l
S t a g e : W a i t i n g f o r A C K
T i m e : 0 . 5 m i n a f t e r c a l l i n g
C a l l - F : 4 2 0 7 . 5 / 4 2 0 7 . 5 k H z
[ C a n c e l ] [ C a n c e l ]
W K R s c a n b a n d s :
2 4 6 8 1 2 1 6 ( M H z )
FUNC key to start from 3 above.
( E X T )
( E X T )