Call Block; Storing Unwanted Callers - Panasonic KX-TG7412C Operating Instructions Manual

TG74xxC(e).book Page 26 Monday, February 16, 2009 1:44 PM
Programming
sleeping. Night mode can be set for each
handset.
Important:
L Set the date and time beforehand
(page 14).
L We recommend turning the base unit
ringer off (page 16) and call screening
off (page 33) in addition to turning the
night mode on. (KX-TG7431 series:
page 3)
L If you have set the alarm, the alarm
sounds even if the night mode is
turned on.
Turning night mode on/off
1
{MENU} (centre of joystick) i
{#}{2}{3}{8}
2
{V}/{^}: Select "On" or "Off". i
{SAVE}
L If you select "Off", press {OFF}
to exit.
3
Enter the desired hour and minute
you wish to start this feature.
4
{AM/PM}: Select "AM" or "PM". i
{OK}
5
Enter the desired hour and minute
you wish to end this feature.
6
{AM/PM}: Select "AM" or "PM".
7
{SAVE} i {OFF}
L When the night mode is set, 3 is
displayed.
Note:
L To correct a digit, push the joystick left
or right to move the cursor to the digit,
then make the correction.
Changing the start and end time
1
{MENU} (centre of joystick) i
{#}{2}{3}{7}
2
Continue from step 3, "Turning night
mode on/off", page 26.
26
Call block (Call Display
subscribers only)
This feature allows the unit to reject calls
when:
– the unit receives a call from a phone
number stored in the call block list as
unwanted ("Storing unwanted callers",
page 26).
– the unit receives a call without phone
number ("Block calls without phone
number", page 27).
When a call is received, the unit rings for
a short time while the caller is being
identified. If the unit recognizes the call
as unwanted, "Caller blocked" is
displayed and the unit sends out a busy
tone to the caller, and then disconnects
the call.
Important:
L When the unit receives a call from a
number that is stored in the call block
list or a call without a recognized
phone number, the call is logged in the
caller list (page 31) with $ after the
call is disconnected.

Storing unwanted callers

You can store up to 30 phone numbers in
the call block list by using the caller list or
by entering the numbers directly.
Important:
L You must store the phone number
with an area code (10 digits) in the call
block list.
■ From the caller list:
1
{MENU} (centre of joystick) i
{#}{2}{1}{3}
2
{V}/{^}: Select the entry to be
blocked. i {SELECT}
L To edit the number, press
{EDIT} repeatedly until the
phone number is shown in the
10-digit format.