Industry Canada Notices And Other Information - Panasonic KX-TG7412C Operating Instructions Manual

TG74xxC(e).book Page 49 Monday, February 16, 2009 1:44 PM

Industry Canada Notices and other information

NOTICE:
This equipment meets the applicable Industry
Canada Terminal Equipment Technical
Specifications. This is confirmed by the
registration number. The abbreviation, "IC:",
before the registration number signifies that
registration was performed based on a
Declaration of Conformity indicating that
Industry Canada technical specifications were
met. It does not imply that Industry Canada
approved the equipment. And, the term "IC:"
signifies that Industry Canada radio technical
specifications were met.
Before installing this equipment, users should
ensure that it is permissible to be connected
to the facilities of the local
telecommunications company. The equipment
must also be installed using an acceptable
method of connection. The customer should
be aware that compliance with the above
conditions may not prevent degradation of
service in some situations.
Repairs to certified equipment should be
coordinated by a representative designated
by the supplier. Any repairs or alterations
made by the user to this equipment, or
equipment malfunctions, may give the
telecommunications company cause to
request the user to disconnect the equipment.
Users should ensure, for their own protection,
that the electrical ground connections of the
power utility, telephone lines and internal
metallic water pipe system, if present, are
connected together. This precaution may be
particularly important in rural areas.
Caution:
Users should not attempt to make such
connections themselves, but should contact the
appropriate electric inspection authority, or
electrician, as appropriate.
NOTICE:
The Ringer Equivalence Number (REN)
assigned to each terminal device provides an
indication of the maximum number of terminals
allowed to be connected to a telephone
interface.
The termination on an interface may consist of
any combination of devices subject only to the
Useful Information
requirement that the sum of the Ringer
Equivalence Numbers of all the devices does
not exceed 5.
The Ringer Equivalence Number (REN) of this
unit: (found on the bottom of the unit).
NOTICE:
Operation is subject to the following two
conditions: (1) this device may not cause
interference, and (2) this device must accept
any interference, including interference that
may cause undesired operation of the device.
Privacy of communications may not be
ensured when using this telephone.
Some cordless telephones operate at
frequencies that may cause interference to
nearby TVs and VCRs. To minimize or prevent
such interference, the base of the cordless
telephone should not be placed near, or on top
of, a TV or VCR. If interference is experienced,
move the cordless telephone further away
from the TV or VCR. This will often reduce, or
eliminate, interference.
RF Exposure Warning:
L This product complies with IC radiation
exposure limits set forth for an uncontrolled
environment.
L To comply with IC RF exposure requirements,
the base unit must be installed and operated
20 cm (8 inches) or more between product
and all person's body (excluding extremities
of hands, wrist and feet).
L This product may not be collocated or
operated in conjunction with any other
antenna or transmitter.
L The handset may be carried and operated
with only the specific provided belt-clip. Other
non-tested belt-clips or similar body-worn
accessories may not comply and must be
avoided.
49