Removing/Installing The Front Cover - Invacare Pronto M41 Series Service Manual

®
Invacare - PRONTO M41
Installing the front cover:
● Pull joystick cable through the center hole in the top cover (5).
● Place the top cover (5) on the base frame.
Note
Pull the cover forward to clear the motor release levers.
● Install the two screws (2) that secure the top cover (5) to the frame (3). Do not overtighten.
● Attach the front cover (1) to the top cover (5).
● Install the two screws (2) that secure both the top cover (5) and front cover (1) to the frame (3).
Do not overtighten.
● Install the seat assembly, as described in chapter 8.9.1.1.
● Connect the joystick, as described in chapter 8.2.3
8.1.2

Removing/Installing the front cover

Requirements:
● Slotted screwdriver
● Phillips screwdriver
Removing the front cover:
● Remove the two screws (2) that secure both the top cover (5) and front cover (1) to the
frame (3).
● Remove the front cover (1) from the frame (3).
Installing the front cover:
● Insert the tabs at the bottom of the front cover (1) into the slots in the bottom of the frame (3).
● Secure the bottom of the front cover (1) to the frame using the two screws (2).
Do not overtighten.
SERVICE MANUAL
37