Electronics; Removing/Installing The Joystick (Office Style Seat) - Invacare Pronto M41 Series Service Manual

®
Invacare - PRONTO M41
8.2

Electronics

WARNING!
After any adjustments, repair or service and before use, make sure that all attaching
hardware is tightened securely - otherwise injury or damage may result.
● Before performing any maintenance, adjustment or service verify that On/Off switch on the
joystick is in the off position.
8.2.1

Removing/Installing the joystick (office style seat)

1 Seat
2 Standard arm
3 Mounting bracket and
adjustment lock lever
Removing the joystick:
● Disconnect the joystick, as described in chapter 8.2.3.
● Cut the tie‐wraps (7) that secure the joystick cable (8) to the arm (2).
● Loosen the adjustment lock lever (3) to release the joystick mounting tube (4) from the
mounting bracket (3).
● Remove the joystick (5) and joystick mounting tube (4) from the mounting bracket (3).
Installing the joystick:
● Slide joystick mounting tube (4) through the mounting bracket (3) to the desired position.
● Tighten the adjustment lock lever (3) to secure the joystick mounting tube (4) to the mounting
bracket (3) on the other arm (2).
● Tie‐wrap (7) the joystick cable (8) to the arm (2).
● Connect the joystick, as described in chapter 8.2.3.
● Ensure the arm (2) can swing fully up without pulling on the joystick cable (8).
4 Joystick mounting tube
5 Joystick
6 Mounting screws
SERVICE MANUAL
7 Tie-wrap here
8 Joystick cable
41