Dear customer! Thank you for purchasing our product. For safety, it is strongly recommended to read this manual carefully before connecting, operating and/or adjusting the product and keep the manual for reference in the future. Table of contents Table of contents.............................2 Important safeguards ..........................3 Installation/Connections ..........................4 Panel controls............................8...
Important safeguards · Using the device at temperature below -10º may cause the breakage of the device. BEFORE USING PLEASE HEAT UP THE PASSENGER COMPARTMENT TO THE RECOMMENDED TEMPERATURE! · Read carefully through this manual to familiarize yourself with this high-quality sound system. ·...
Installation/Connections First complete the electrical connections, and then check them for correctness. If you are not confident working with electrical wiring, removing and reinstalling interior panels, carpeting, dashboards or other components of your vehicle, please call your dealer in order to have the unit professionally installed. Before the installation IMPORTANT: Remove two screws before installation.
Page 5
3. Insert trim plate. When you prepare to insert trim plate, please check it s direction. Once it was up side down, it cannot be fixed. NOTE: Outer trim frame, hook, and mounting sleeve are not used for this installation. This is only intended as a general guide;...
Page 7
Using the ISO Connector 1. If your car is equipped with the ISO connector, then connect the ISO connectors as illustrated. 2. For connections without the ISO connectors, check the wiring in the vehicle carefully before connecting, incorrect connection may cause serious damage to this unit.
Panel controls Front panel 1. VOLUME-UP/DOWN, PUSH SEL MENU 2. LOADER 3. LCD (LIQUID CRYSTAL DISPLAY). 4. POWER BUTTON. Press more than 2 seconds to power off. 5. IR SENSOR 6. AUX input 7. TUNING UP/DOWN, PUSH MOD 8. BAND/NP BUTTON. Press it repeatedly to select your desired radio band during RADIO mode.
Page 9
10. CLOCK BUTTON 11. APS/SUB BUTTON 12. EJECT BUTTON 13. EQ/LOUDNESS 14. MUTE BUTTON Press in 1 second to MUTE ON, press it again 1 second to MUTE OFF 15. FM STEREO/MONO Back of the front panel Press the button to open the panel. Disc slot: insert a disc for playback here Panel status indicator Reset hole...
ISO connector PLEASE USE ONLY ORIGINAL CONNECTOR WHICH GOES WITH SET. Note: ·In spite of having any kinds of speaker system, must use 4 ohms impedance of speaker to reduce the distortion during high volume level.
Battery information of remote controller 1. Press the catch and at the same time pull out the battery tray. 2. Insert the 1 x lithium battery, type CR 2025 3V battery with the stamped (+) mark facing upward. Insert the battery tray into the remote control.
Glossary PBC (PlayBack Control) PlayBack Control is a menu recorded on the disc with SVCD or VCD2.0 format. For the discs contained PBC, it can playback interactive software with the menu displayed on TV. And if the disc contains still images, it can playback high definition of still image.
Features Fully compatible Fully compatible with the most popular discs formats such as DVD, CD, CD-R (containing MP3, JPEG), CD-RW represented in the market. Upgrade intelligently Support the function of upgrading the software for playing discs of new formats to keep up with the market competition.
Compatible discs DVD Video DVD disc include video and audio data. The data can contained by the 12 cm diameter of DVD disc is 7 times of one can contained by the common CD-R disc. Its maximum continuous playback time can be up to 2 hours (one of double-sided disc can be up to 4 hours).
Page 16
CD-R/CD-RW Compatible with CD-R/CD-RW disc with ISO9660 specification include the format of MP3, JPG, JPEG, Ac3, PCM, MP4, MPEG. DVD+/-R Compatible with DVD+/-R disc with UDF specification include the format of MP3, JPG, JPEG, Ac3, PCM, MP4, MPEG4, DivX (3.11/4.0/5.0/6.XX). Note: Support of MPEG4 Standard: playback of digital video compressed in DivX 3.11, DivX 4.0, DivX5.0, DivX...
General operation Power button Press POWER button on the front panel or any other button on the panel except EJECT to turn on the unit. Press POWER to switch the set to POWER OFF. When you switch off the system or car ignition, the settings, tuner presets and the volume level will be retained in the unit s memory.
Page 18
Adjusting clock Setting the clock time 1. Press and hold CLK for more than 3 seconds to select the hour setting. Hour digits will blink. 2. Rotate the control to set the hours. 3. Press VOL knob to select the minute setting. Minute digits will blink. 4.
Digital tuner Choose Radio Band Press the MODE Button to access the radio function. The unit comes with five bands- three FM Bands (FM1, FM2, and FM3) and two AM Bands (MW1, and MW2). Each of the five bands can store up to six preset stations, for a total of 30 preset memory stations.
Page 20
Automatic Store/Preset Scan A. Automatic Scan & Store While listening to the FM Radio, press and hold the APS Button for 3 seconds. The receiver will automatically scan and save stations for all the 3 FM Bands, whichever band (FM1, 2 or 3) you are listening to. While listening to the AM Radio, press and the APS Button for 3 seconds.
DVD/VCD/CD/MP3/CD-R Discs for playback · This set can play all digital audio CD, HDCD, CD-R/RW, MP3,WMA, VCD, SVCD, DVD, DVD-ROM. · The following file types are supported: Audio files: MP3 (*.mp3) WMA (*.wma) Video files: MP4 (*.avi, DIVX3.11/4.0/5.0/6.XX and XVID) MPEG 2(*.vob) MPEG 1(*.dat) Picture file: JPEG (*.jpg)
Page 22
OSD (Display information) Press the OSD button (by pressing and holding button 1 on the front panel, or pressing the OSD button on the remote control) so that the OSD will be display on the monitor. Details such as title, track, playtime, etc, will be shown.
Page 23
Button 2: Right + Repeat Press the No.2 Button to navigate the setup menu right-ward. Press and hold the button for 3 seconds for repeating the same track continuously. RPT" will appear on the display. Press and hold this button again to stop repeating.
Page 24
Subtitle Selection Press the Sub-T button on the remote control to choose the subtitle you want. The subtitle languages available differ from Disc to Disc. You can also use the setup menu to confirm. Refer to the packing of the Disc for details. Track Time Search Press the GOTO button on the remote control to search the desired track time to play the Disc.
Page 25
Programme Mode Press the PROG button on the remote control to set the program play. Use the Navigation and Digit keys to set the Chapter and Track no. as your desired sequence. Press Enter to begin the program play. Press the PROG button and confirm a blank program again to cancel this operation.
Mixed-disc operation While you are playing mixed disc, which contains MP3, WMA, JPG or DIVX formats, just insert the disc into the CD slot and the menu on the right hand side will be promted. The unit will directly play the audio files. However, you can use the navigation and Enter keys to select the format that you would like to view/listen to.
Page 27
Button 1-6 The functions of button 1-6 also apply to the mixed-disc play. Back to the menu If you would like to go back to the playlist menu to choose the other file to view/listen to, press and hold button No.5 to stop the playback.
VCD/CD operation Insert/Eject CD Insert a disc into CD slot with label side up. The disc will be automatically loaded into the unit, even when it is off or at radio mode. The word LOAD will show on the display and the disc will play automatically. Press the EJECT Button to eject the disc from the slot.
Page 29
VCD: Press AUDIO during playback. It is possible to switch the sound between mono and stereo sound. The sequence is as follows: Left Vocal --> Right Vocal --> Mono Left --> Mono Right --> Stereo CD: Press AUDIO during playback. It is possible to switch the sound between mono and stereo sound.
AUX IN, RCA OUT, SUB OUT&Video OUT Auxiliary Input The Auxiliary Input Jack is on the rear of unit. Insert the RCA plugs into the AUX IN jack on the front of the unit. Route the other end of the RCA to the any external audio device such as walkman and discman. Press and hold the Mode button to choose AUX.
Menu operation Press SETUP button on the remote control to display setup screen, use , ENTER buttons to select the desired item: System, Language, Audio, Video, Digital. System setup TV system Select the TV system in the setting menu. Screen saver The screen saver appears if disc stop last more than 3 minutes.
Page 32
Video output mode Original setting: INTERLACE-YUV. Setting TV type Select TV type to watch wide screen movies. 4:3 Pan Scan: For 4:3 TV, left and right edges will be cut. 4:3 Letter Box: For 4:3 TV, black bars will appear on top and bottom. 16:9: For 16:9 wide screen TV.
Page 33
Note: The rating can be selected only under the password unlocked status, and the limits can be worked only under the password locked status. Load default If this item is selected, the unit will return to original setting. Language setup Setting the on-screen display language Select the language to be used for the on-screen display.
Page 34
Setting the subtitle language Select the language to be used for the Subtitles. You can select a preferred subtitle from those included in the DVD Video disk. (The screen on your player may have difference with the screen shown here) Setting the menu language Select the language to be used for the Menu.
Page 35
Setting volume Setup the volume with the buttons. Video setup Brightness Set the brightness of the video output with Contrast Set the contrast of the video output with Set the hue of the video output with...
Page 36
Saturation Set the saturation of the video output with Sharpness Set the sharpness of the video output with Digital setup Output mode Select the output mode: LINE OUT: Compress the input signal. The volume is small. RF REMOD: The volume is large.
Page 37
Dynamic range When you select the compressed mode as line out , select it to adjust the compression proportion and get the different compressed effect. When select FULL, the audio signal is minimum; when select OFF, the audio signal is maximum. Dual mono Select the audio channel from STEREO, MONO L, MONO R and MIX MONO.
Anti-theft system Removing the panel 1. Press POWER button to switch off the power of the unit. 2. Press EJECT button to flip down the panel. 3. Hold the middle of the panel. Take off one end, and then take off the other end. 4.
Handling discs · Dirty, scratched or warped discs may cause skip ping or noise. · Handle the disc only by the edges. To keep clean do not touch its surface. · Discs should be stored in their cases after use to avoid scratches. ·...
Troubleshooting guide Cause Solution Symptom General The car ignition is not on. If the power supply is properly connected to No power the car accessory switch the ignition key to ACC . The fuse is blown. Replace the fuse. Disc Presence of disc inside the player.
Specification General. Power supply: 12V DC Current consumption/Fuse: 8A/ 10A & 1A Maximum power output: 50Wx4 channels Dimensions (W x H x D) 178 x 51 x 178 mm Working temperature range: -20º +60º FM Stereo Radio. Frequency range: 87.5 - 108.0 MHz Usable sensitivity/ I.F.
Need help?
Do you have a question about the SM-CMD2020 and is the answer not in the manual?
Questions and answers