Left Coffee Bean Hopper - Saeco NEXTAGE CAP010 Use And Maintenance

Selecting the Coffee Bean Hopper
This control allows the user to select which coffee bean
hopper he/she would like to use to brew the coffee
bean-based beverage.
This selection is available only if the machine is
equipped with 2 coffee bean hoppers.
This selection is available only if the recipe of the
selected beverage does not specify the coffee bean
hopper to use.
The following picture shows the two available options: The
one on the left indicates that the left coffee bean hopper is
being used, the one on the right indicates that the right
coffee bean hopper is being used.
Adjusting the Height of the Dispensing Spout
If the machine is programmed to allow the dispensing
spout height to be adjusted, the icon shown in the
following picture will be visible on the display.
This control allows the dispensing spout to be adjusted at various
heights so that glasses of different sizes can be used.
The picture below shows the minimum and maximum
heights possible.
h1 70 mm
h2 200 mm
Beverage Multiplier
This control allows the user to multiply the number of
beverages to be brewed.
Every time the icon shown in the figure is pressed, the
counter increases by 1 unit from a minimum of 1 to a
maximum of 8 beverages.
After pressing the multiplier icon, only the beverages
programmed for being multiplied will still be enabled.
If no beverage icon is pressed within 5 seconds after
pressing the multiplier icon, the counter is reset to 1.
During the beverage brewing, the number of the
current brewing process and the total number of the
required beverages is displayed.
Beverage Brewing
To brew a beverage press the icon corresponding to the
required beverage.
During the beverage brewing, a screen with the following
layout is displayed:
• On top, the product brewing bar.
• In the middle, the picture of the beverage being brewed in
that moment.
English
71