Operating Overview - Connections, Keys, Rotary Switch, Symbols - Gossen MetraWatt METRAHIT EXTRA Operating Instructions Manual

High resolution trms digital multimeter
Hide thumbs Also See for METRAHIT EXTRA:
Table of Contents

Advertisement

Operating Overview – Connections, Keys, Rotary Switch, Symbols
2
Operating Overview – Connections, Keys, Rotary Switch, Symbols
15
chapter 3.1
chapter 6
14
chapter 3
13
12
chapter 6
11
chapter 4.4
10
chapter 4.1 
Max. 1000 V!
* METRAHIT E
: Current measurement by means of current clamp sensors with
BASE
voltage output only
12
chapter 7
1 Display (LCD) (see page 13 for significance of symbols)
16
2 MAN / AUTO shift key for manual/automatic measuring range selection
*
3 ON / OFF | LIGHT key for switching device and display illumination on and off
chapter 4.3
4 FUNC | ENTER multifunction key
1
Operating mode menu: Acknowledge entry (ENTER)
5
chapter 4.1.2
2
6 Rotary switch for measuring functions, (see page 15 for significance of symbols)
7 DAkkS calibration mark
chapter 3
3
8 Connector socket for ground
9 Connector socket for current measurement with automatic blocking
chapter 5
4
10 Connector socket for voltage, resistance, temperature, diode and
capacitance measurement with automatic blocking
chapter 6
5
11 DATA/MIN/MAX
Key for freezing, comparing and deleting measured value, and for Min/Max
chapter 3 ff.
6
12 MEASURE | SETUP
chapter 1.2
Key for switching back and forth between measuring and menu function
7
13 ZERO | ESC
chapter 3
8
Key for zero balancing
Operating mode menu:
*
chapter 4.1
9
14
15 Connector for power pack (METRAHIT E
16 Infrared interface
Increase parameter values
Operating mode menu: Select individual menu entries against direction of flow
Increase measuring range or move decimal point to the right (MAN function)
Decrease values
Operating mode menu: Select individual menu entries in direction of flow
Exit current menu level and
return to a higher level,
exit parameters configuration
without saving data
Decrease measuring range or move decimal point to the left (MAN function)
only)
XTRA
GMC-I Messtechnik GmbH

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the METRAHIT EXTRA and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Metrahit etechMetrahit especialMetrahit ebase

Table of Contents