EarthQuake XJ-300 FR User Manual page 9

5) 110V/220V Option:
Should already be set to the
correct voltage depending
on your region.
4) Speaker Outputs:
A) To use the XJ-300FR as a two channel amplifier, connect the right
speaker to the R+ and R- terminals and the left speaker to the L+
and L- terminals.
B) To bridge the XJ-300FR as a one channel amplifier (or mono
block), connect the positive speaker wire to the L+ terminal and
connect the negative speaker wire to the R- terminal. Do not
connect anything to the two lower black terminals.
C) To use the XJ-300FR as a 2.1 channel amplifier, connect the right
speaker to the R+ and R- terminals and the left speaker to the L+
and L- terminals. Then, connect the subwoofer positive to the L+
terminal and the subwoofer negative to the R- terminal.
5) 110V/220V:
Do not attempt to change the voltage setting. The amplifier should
already be set to the correct voltage depending on your region. If not,
please contact your local Earthquake Sound dealer.
6) Power Supply:
To access the 6A/250V replacement fuse, use a flat head screwdriver
to pry off the plastic cover. Make sure that the amplifier is not connected to
any power source when doing so.
Specifications are subject to change without notice
6) Power Supply:
Comes with a 6A/250V
replacement fuse directly
under power inlet.
XJ-300FR Manual 9