LSI LSI21002 User Manual page 28

2-12
Step 4. Most PC cabinets are designed with a front panel LED, which
may already be connected to an existing IDE controller. You
may connect this LED cable to your SCSI host adapter, as
shown in Figure
LED to indicate activity on the SCSI bus.
The Busy LED connector J6, shown in
The J6 connector is a 4-pin one row right angle header for both
Channel A and Channel B.
Some LED cables have only two wires. In this case, place the
connector on one end of J6. If the LED does not light during
SCSI bus activity from this host adapter, you may have to rotate
the LED connector 180 ° on J6.
See Table A.7 in Appendix A
Figure 2.8 SCSI LED Connector
Installing the LSI21002
2.8. This connection causes the front panel
for connector pinout information.
Figure 2.1, is not keyed.