Cutting Unit Specification; Recommended Lubricants - Ransomes 51 Marquis Safety, Operation & Maintenance Manual

4 SPECIFICATIONS
4.7

CUTTING UNIT SPECIFICATION_________________________________________

Front roll
Two piece Aluminium with bevel gear
Landroll
Cutting cylinder All welded 10 knife cylinder running on ball bearings
Cutting ratio
Height of cut
Cutting width 51cm (20in.)
Cutting 1110 sq. m./hr
performance (1330 sq. yd./ hr)
0.28 kg./cm
Ground Pressure
(4lb./in
NOTE
These cutting units are made to cut grass of maximum height 100 mm down to the available height of cut range.
4.8 CUTTING PERFORMANCE _____________________________________________
51cm (20in) width of cut:
1110 m/hr.
1330 y/hr
(10% allowance is included for normal overlaps and turning at the end of each cut.
61cm (24in) width of cut:
1660 m/hr. At 12 kph.
1920 y/hr at 7.5mph
10% allowance is included for normal overlaps and turning at the end of each cut.
4.9

RECOMMENDED LUBRICANTS _________________________________________

Engine oil: A.P.I. Classification SJ grades.
TEMPERATURE OIL VISCOSITY
-15°C - +40°C SAE 5W-30
Grease: Lithium based general purpose grease
4.10 ACCESSORIES ______________________________________________________
4.10.1 TRAILING SEAT KIT __________________________________________________
A trailing seat is available for the Marquis 61.It is attached by a one pin hitch. Only use a Ransomes trailing seat
(LMAA628) and towbar(LMAA747) with this machine.
en-20
Super Certes
51 61
One piece steel roll running on ball bearings
differential
142 cuts/ metre
(130 cuts/ yd)
3 - 13mm (1/8 - 1/2in.)
61cm (24in.)
1660 sq. m./hr
(1920 sq. yd./hr)
2 2
0.32 kg./cm
2 2
) (4.5lb./in )
Super Bowl
51
Two piece smooth cast
iron with bevel gear
differential
All welded 6 knife
cylinder running on
85 cuts / metre
51cm (20in.)
1110 sq. m./hr
(1330 sq. yd./ hr)
2
0.28 kg./cm
2
(4lb./in )
Marquis
51
Four piece wood roll
Two piece ridged cast iron with
bevel gear differential
All welded 5 knife
cylinder running on
ball bearings ball bearings
71 cuts / metre
(78 cuts/ yd) (65 cuts/ yd)
6 - 27mm (1/4 - 1 1/16in.)
61cm (24in.)
1660 sq. m./hr
(1920 sq. yd./hr)
0.32 kg./cm
(4.5lb./in
61
2
2
)