Testing The Battery Pack - Midtronics MDX-700P HD Instruction Manual

5. After you complete testing on the last battery, the MDX-700P HD displays
the results. Press the DOWN ARROW key to view the individual battery re-
sults. See an example of the results on the next page.
6. You may print the results of the testing.
7. If the result of the pack test is "Good Pack", the MDX will continue on to the
Starter Test (refer to Starter Test section for instructions).

Testing the Battery Pack

1. At the start of the test, make sure all vehicle accessory loads are off, the key
is not in the ignition, and the doors are closed.
2. Connect the clamps to the positive (+) and negative (-) cables that lead to
the starter chassis ground as shown. If there are multiple cables, re-test for
each cable connection.
3. For a proper connection, rock the clamps back and forth. Both sides of each
clamp must be firmly connected before testing. If the message CHECK
CONNECTION appears, clean the terminals and/or reconnect the clamps.
www.midtronics.com 17
MDX-700P HD