Adaptec Snap Server 700i Series Service Manual page 9

Replacing a PCI Card
Connect the SAS cable to the card.
4
Replace the expansion cage in the chassis and tighten the two thumbscrews.
5
Replacing an Ethernet Card
Once you have removed the expansion cage from the chassis, insert the NIC into
1
the appropriate PCI slot, snap it in place, and screw in the PCI card bracket.
Replace the expansion cage in the chassis and tighten the two thumbscrews.
2
Replacing the Top Cover
Be sure to replace the top cover. Do not operate the server if the cover is not in place.
Lower the top cover onto the server.
1
From the rear of the server, push the cover forward until it is firmly seated.
2
Replace the screw on the right side of the server.
3
Restoring Power to the Server
If you removed the server from the rack, replace it now with the help of another
1
person.
Reattach all cables to the rear of the server.
2
Push the power button on the front of the server to boot up the server.
3
4
Copyright © 2007, Adaptec, Inc. All rights reserved. Information in this document is subject to change without notice and does not represent
a commitment on the part of Adaptec or any of its subsidiaries.
NIC PCI slot
Snap Server 700i Series
Field Service Documentation