Removing The Snap Server From A Rack - Adaptec Snap Server 700i Series Service Manual

Snap Server 700i Series

Removing the Snap Server from a Rack

Once the Snap Server is installed in the rack, it locks into place. To remove the
server, perform the following steps:
Unscrew the screws securing the server on the front and rear of the rack.
1
Slide the server forward (as shown in the illustration).
2
Release mechanism
Once the server is extended, press the release mechanisms on the inner rails
3
attached to the chassis down at the same time and slide the server the rest of the
way out of the rack.
The server is heavy and awkward. Do not try to remove it without
Caution
another person's assistance.
Field Service Documentation
Copyright © 2007, Adaptec, Inc. All rights reserved. Information in this document is subject to change without notice and does not represent
a commitment on the part of Adaptec or any of its subsidiaries.
Removing the Snap Server from a Rack
5