Replacing A Dimm - Adaptec Snap Server 700i Series Service Manual

Snap Server 700i Series

Replacing a DIMM

Remove the Caution label covering the DIMM(s).
1
As stated on the label, only replace the DIMM with another DIMM supplied by
Adaptec.
Remove the DIMM.
2
To release the DIMM from its slot, press the white latches on both sides of the
module down and outward. Grasping the edges of the module, lift it out of its
slot and set it aside.
Front of Server
Latch
Remove DIMM
Insert the new module into the same slot.
3
Grasping only the edges of the module, insert it into the same slot, avoiding
contact with metal surfaces on the module.
Push the module in until the latches mostly engage. Then secure the latches to
4
close the final gap.
Field Service Documentation
Copyright © 2007, Adaptec, Inc. All rights reserved. Information in this document is subject to change without notice and does not represent
a commitment on the part of Adaptec or any of its subsidiaries.
Latch
Replacing DIMMs
3