Installing Qu-Pac - ALLEN & HEATH Qu-Pac Getting Started Manual

4. Installing Qu-Pac

Fit the ears to the
case using 2x
M4x8 screws per
side.
Note Allow adequate air flow around the ventilation slots at the rear and through the inside section of the
case. Do not block the sides.
Dimensions
Shown in millimetres (inches)
Qu-Pac Getting Started Guide
Rubber feet
440 (17.32") Free Standing
7
Free Standing
- For operating while on a
desk, shelf or other flat surface.
Make sure the 4 rubber feet are fitted.
Allow space at the sides and rear for ventilation.
The mixer can be transported in a purpose
designed padded bag or flight case.
Optional polyester Qu-Pac padded carry bag
AP9931 is available from Allen & Heath.
Rack Cased
- For operating while fitted into
a 4U space in a standard 19" equipment rack or
flight case.
Choosing a 'shallow' case with internal depth of
200mm (8") or more to allow easy access to the
rear connectors.
The mixer front panel is angled upwards to allow
easier access to the controls while in the rack.
Qu-Pac is shipped with a rack ear kit to convert
from free standing to rack operation. To fit the
rack ears:
If necessary, remove the 4x rubber feet by
prizing the central plastic grommet out
using a small flat bladed screwdriver.
274 (10.8") to allow for connections
Secure Qu-Pac into the
rack using 2x M6x16
screws (AB0344) and
plastic cups (AB0345)
per side.
122 (4.8")
Angle
17 degrees
(6.85")
174
AP9815 iss2