4. Installing Qu-SB
Gap for ventilation and cables
Fit
the
rack
ears
(AA10262) to the mixer
using the 2x M4x8
(AB0332) screws per
side. Use a Torx T20
driver.
Dimensions -
123
Angle
17 degrees
Rack Mounted
38
Qu-SB Getting Started Guide
Rubber feet
Shown in millimetres (inches)
483 (19") Rack Mounted
Free standing
- For operating while on a stage
or other flat surface. Make sure the 4 rubber feet
are fitted.
- Allow space around the unit for ventilation.
Run the cables to avoid a trip hazard.
The mixer should be transported in a purpose
designed padded bag or flight case.
Rack Mounted
- For operating while fitted into
a 4U space in a standard 19" equipment rack or
flight case. The front panel is angled upwards to
allow easier access to plug in the cables. A gap
underneath the unit lets you feed cables through
from within the rack.
Rack mounting option kit QU-SB-RK19 is
available from Allen & Heath.
- Ensure adequate air flow. Do not block the
rear ventilation slots or the gap underneath the
front of the unit.
To save space a 'shallow' case with internal depth
of 200mm (8") or more is recommended.
The rubber feet do not need to be
removed. If you do wish to remove them
then unscrew using a Torx T20 driver.
436
(17.32") Free Standing
8
Secure Qu-SB into the
rack using the 2x M6x16
screws (AB10301) and
plastic cups (AB0345)
per side.
Angle
21 degrees
161 (6.34") Free Standing
AP10287 iss1