Delayed Start - Electrolux EDW 1500 - 1510 Service Manual

MODELS WITH SEQUENTIAL SELECTION: in these versions two buttons are used to select the
programmes
1. Close the door and switch the appliance on [S0]
The display shows [ --]
2. Press button [+ ] to select with an increasing order:
The LEDs relative to the programme buttons light (if featured)
The display shows the last selected flashing programme.
Every time the button is pressed the following programme is
selected (increasingly):
3. Press button [- ] to select with a decreasing order:
The LEDs relative to the programme buttons light (if featured).
The display shows the last selected flashing programme. Every time the button is pressed the previous
programme is selected:
4. Within 3 seconds after the programme selection it is possible to set the possible option or the delayed
start (if available).
5. Automatically, 3 seconds after the last pressure of a button, the cycle starts.
The digits and the LED indicating the current phase are on
4.4.1

Delayed start

Proceed as follows to select the delayed-start time:
1. Close the door and switch the appliance on by means of the S0 button
2. Press the button repeatedly to select the delayed-start time which appears flashing on the display
Every time the button is pressed, the time increases every hour up to 19h [
3. Select the programme and the possible options
For some seconds the display shows the time-to-end of the cycle, the LED corresponding to the
selected programme lights, then the delay time is shown again
4. 3 seconds after the last selection, the delay time is activated
The display lights steady and the countdown starts: the time decreases every hour [ 19h
1h 0h].
5. During the countdown, till the programme starts, it is possible to modify the delay time or cancel it.
6. the programme starts automatically.
The display shows the time-to-end of the cycle
The delayed-start countdown can also be selected as follows:
1. Press button S0 to switch on the appliance.
2. Select the programme and the possible options.
3. Within 3 seconds, press sequentially the button to select the delay time.
4. 3 seconds after the selection the delay time and the countdown start with the same modalities previously
described.
SOI/TD - PR
1 2 3.....
7 6 5 .....
9
.....19
1 2 3
18h 17h...
599 36 01-86
0..]