Sequence Of Operations - Electrolux EDW 1500 - 1510 Service Manual

4.8 Sequence of operations

1. Close the door
2. Press S0 to switch the appliance on
The pilot lamps L0, salt and rinse-aid
light
3. Select the desired programme
The LED corresponding to the chosen
programme and the LEDs of the phases
light
The display shows the time-to-end or the
programme no. flashing
4. Within 3 seconds select the possible
delayed start or the desired option (if
featured)
5. Automatically, 3 seconds after the last
pressure of a button, the cycle starts.
The digits and the current phase LED
light steady.
6. The time-to-end decreases every minute
and is updated after every cycle phase.
The LED indicates the current phase.
7. To interrupt a current programme:
Switch the appliance off with S0 (or open
the door)
To start it again, press S0 (and close the
door)
8. To cancel a current programme:
Press S2 – S3 simultaneously until the
selection mode appears again
9. At the end of the programme:
The buzzer sounds at intervals.
The END OF CYCLE LED lights.
The display shows [0].
10. Press S0 to switch the appliance off.
SOI/TD - PR 12 599 36 01-86