Sony KP-43T90 Operating Instructions Manual page 54

,ii Operating a Cab/e Box or Satellite Receiver (SAT)
Setting the Manufacturer's
Manufacturer code numbers
To operate the projection TV
Code
(satellite receiver)
Press TV (FUNCTION). Then use the
Manufacturer Code number
projection TV control buttons to control the
You can program the supplied remote control
projection TV.
to operate a cable box or satellite receiver.
Sony 801 (preset code for
Press CODE SET, SAT/CABLE
remote control)
General Electric
(FUNCTION), and the O-9 buttons to enter
802,808
Hitachi
a05
Tips $
..-_
the manufacturer's code number (see the
following chart), then press ENTER.
Hughes 804
l
Panasonic 803
For example, to operate a Sony satellite receiver:
RCA/PROSCAN 802
F"NCTlON
Toshiba 806,807
l
Manufacturer code numbers
(cable box)
%
Manufacturer Code
Hamlin/Regal 222,223,224,225,226 z
JerroWG.1 201,202, 203,204,205, 3
222,206,207,208,218
Oak 227,228,229
Panasonic 219,220,221
Pioneer 214,215
Scientific Atlanta 209,210,211
Tocom 216, 217
Press SAT/CABLE (POWER) [Green
Button] to turn on/off the cable box or
satellite receiver.
.
Press SAT/CABLE (FUNCTION).
For other operations, refer to
the
operating instructions that come with the
equipment.
The GUIDE and INDEX (blue-labeled)
buttons can be used only with a satellite
receiver.
lfmore than one code number is listed, ty entering
them one by one until you come to the correct code
for your equipment.
lf you enter a new code number, the code number
you previously entered at that setting is erased.
In some rare cases, you may not be able to operate
your equipment with the supplied remote control. In
this case, use the equipment's own remote control
unit.
Whenever you remove the batteries - to replace
them, for example - if too much time is taken, the
code numbers may revert to the factory setting and
must be reset.
Zenith 212,213
If the remote control doesn't work
l
Try repeating the set up procedures using
the other codes listed for your equipment.