Connecting; Component Video Output; Connectors - Sony KP-43T90 Operating Instructions Manual

Connecting a DVD Player (Upper
illustration)
Using an AUDIO and S VIDEO cables,
connect AUDIO and S VIDEO IN on the
projection TV to AUDIO and S VIDEO OUT
on the DVD Player (White-AUDIO Left, Red-
AUDIO Right).
Connecting a DVD Player with
component video output
connectors (Lower illustration)
1
Using an AUDIO cable, connect AUDIO of
LINE OUT on the DVD Player to AUDIO of
VIDEO 4 IN on the projection TV (White-
AUDIO Left, Red-AUDIO Right).
2 Using three yellow VIDEO cables, connect
Y,
PB,
and
PR
of COMPONENT VIDEO
OUT on the DVD Player to Y, I's, and
PR
of
VIDEO 4 IN on the projection TV.
Notes:
l
Since the high quality pictures on a DVD
disc contain a lot of information, picture
noise may appear. In this case, adjust "Noise
Reduction" in the Video menu. (see "Noise
Reduction" on page 26)
l
Some DVD Player terminals may be labeled
differently. If so, connect as follows:
Connect Y (green) to Y.
Connect
PO
(blue) to
CB,
Cb or B-Y.
Connect
PR
(red) to
CR,
Cr or R-Y.
l
This projection TV does not support
progressive scan DVD players output. Please
use the interlaced output.
Disconnect all power sources before making any connections.
(Rear of projection
S VIDEO ,
AUDIO-L
DVD
I
I
RK-74A (not supplied)
I
YC-IW/~~V (not supplied)
direct/y to the projection TV.
Connecting the DVD Player
through other video
equipment will cause
(Rear of
orojection
TX