Pioneer XY series Installation Manual page 36

3 Rigging And Caster Setting
__________________________________________________________________________________________________________
Note:
・
When the hook clamp is mounted in the very rear mounting point,
the inclined angle of the both enclosures is shown below.
36 deg(XY-122) and 29 deg(XY-152) when the angle between the
two enclosures is at 50 deg (minimum degrees) and
29 deg(XY-122) and 22 deg(XY-152) when the angle between them is
at 95 deg (maximum degrees).
(7) Ensure the two commercially-available eyebolts are secured to the
mounting points on both edges of the top of the XY-122/152 enclosures
to suspend it with wire as a secondary safety feature. (Fig.3-2-4-M)
Note:
・
Eyebolts to be used as secondary safety feature cannot be mounted
if the angle between the 2 enclosures is below minimum degrees.
Since eyebolts should be mounted to the enclosure as secondary
safety feature, the angle between the 2 enclosures should be
between minimum degrees and maximum degrees in order to
mount the eyebolts.
(J)
(O)
(N)
(N)
(K)
Fig.3-2-4-L
Commercially
-available
eyebolt
Fig.3-2-4-M