Pioneer XY series Installation Manual page 31

3 Rigging And Caster Setting
__________________________________________________________________________________________________________
Part list (CP-XY12DF1/CP-XY15DF1)
Item Part Name
A Dual Enclosure Flying Plate
B M10 socket head bolt
C Spring washer
D Flat washer
E Nut
M8 socket head bolt
F
(Only CP-XY12DF1)
M8 flat washer
G
(Only CP-XY12DF1)
M8 nut
H
(Only CP-XY12DF1)
Procedure
(1) Remove the eight pre-inserted mounting screws on the top and the
bottom of 2 units of XY-122/152. (Fig.3-2-4-A)
(2) Using the supplied M10 socket head bolts(B), tentatively align the
mounting holes on the Dual enclosure flying plate(A) with the mounting
points of the top and the bottom of the enclosure. Ensure that both the
Spring washer(C) and Flat washer(D) are used in between the Dual
enclosure flying plate(A) and the M10 socket head bolt(B). Tighten the
bolts over 15N·m torque. (Fig.3-2-4-B)
Qty Service Part No.
2 -
9 06G053
9 06D015
13 06D014
3 06E012
3 06G046
5 06D009
3 06E010
NOTE: XY-122 is shown in the illustration.
Fig.3-2-4-A
Note
M10 x 40mm (P=1.5),
8mm hex socket head
M10
M10
M10
16mm width across flat
M8 x 30mm(P=1.25),
6mm hex socket head
M8
M8
13mm width across flat
(A)
Fig.3-2-4-B
Required tools
・Screwdriver
・8mm hex key
・16mm hex
spanner
(B)
(C)
(D)